Which front paddock stand to use with an Abba Stand?

I use this n so far it's been ok.

You can lift both front and rear off the ground simultaneously

Since you already have the stand, you just need to invest in the front lift adapter

http://abbastands.co.uk/product-detail.asp?item=front-lift-arm&pid=42

 

I've got an Abba stand too and also not smitten by a strap round swing-arm. Santa's bringing me one of these.
Got to be better than a couple of bottle jacks under the fork legs I've managed with so far.
I do run a ratchet strap under the top yoke and over a joist in the garage roof as insurance though.

 

car jack for a tenner from ebay works well with a piece of timber to protect the frame

 

You don't have to strap it through the swingarm. I have the - Triumph V1 Hub Spindle for Triumph Speed Triple/R (11 to 16). It's an extended Spindle (similar to the rear paddock stand which gets fed through the Hub), you just have to strap it to the extended Spindle

 

^^^ That's correct.

I have R&G axle sliders. I just take them off as it's a 5 sec job ;-). But as you said I wouldn't be comfortable strapping directly through the swingarm.

The front stand (Col_c) put up does look good. I guess you just need the right adaptor and you are good to go

 

I haven't checked size but I'd say as long as a pin goes in it doesn't have to be a great fit, don't imagine it can jump off too easily.

 

Front stand works well with an Abba stand, only thing I had to do was put about 10mm packers under the Abba stand to gain enough clearance under the back wheel.
SWMBO's StreetTriple (lowered suspension) was fine without any packers, it has more space under back wheel when up on stand.

 

I used the Abba stand with the attachment for raising the front wheel on my Fireblade. It was way more stable than any paddock stand I've ever used.