Hee hee Had to go shopping with the wife today and we went into Wilko Spotted these....only £2 each....stainless steel and shiny I’m in work wed/thur/fri so hopefully get these cut up and finish the side panel and sprocket cover to match
Started to put the mesh on the back of the side panel Can only do it bit by bit as the side panel is curved and the mesh lifts away Patience Dilligaf patience Started putting the same mesh on the inside of the sprocket cover as well should of been further ahead with these but I’ve been overhauling my brakes at the same time
Last piece of mesh going on Got the sprocket cover mesh finished should be finished tomorrow morning sometime Next picture should be both of them fitted to my BPOS
TA-DA ...it’s finished Pretty chuffed with it really here it is on the BPOS along with the sprocket cover that’s it then hmmm....think I’ll have a go at making some sort of screen next ...something that will hide the ugly bit between the speedometer and the headlights where all the cables are
I think you are one of the few "customizing" on here and your doing it well. Ill buy you a drink at the GMU, cheers.