Mods For The Rs

Ok, I’ve ordered some goodies for the RS.

-Motodynamic integrated tail light.
https://www.motodynamic.com/2011-20...e-r-s-rs-sequential-led-tail-light-smoke.html
-Gyeon Quartz Q2 ceramic Matt paint coating
http://gyeonquartz.com/product/matte/
-Evotech tail tidy
https://motostarz.ca/products/evote...eliminator-kit-2016-2017-triumph-speed-triple
-Evotech crash bobbins
https://motostarz.ca/products/evotech-performance-frame-crash-bobbins-sliders-kit-2016-2018-triumph-speed-triple-rs
-Evotech rad and oil cooler guards
https://motostarz.ca/products/evotech-performance-radiator-oil-cooler-guard-2016-triumph-speed-triple-r-rs
-Rizoma Corsa turn signals
https://motostarz.ca/products/rizoma-corsa-indicator-turn-signal-each
-Pitbull rear stand
https://motostarz.ca/products/pit-b...h-w-single-sided-swingarms-includes-both-pins
-Evotech rear axle sliders
https://motostarz.ca/products/evote...le-bobbins-2016-2017-triumph-speed-triple-r-s
-I have Triumph front axle sliders from the Street Triple that fit
-Still trying to decide on tank pads. Update: TeckSpech XLine tank pads
-Removed exhaust baffles but left discs in (awesome)
-Rizoma foot pegs

I think that’s it for now.

 

Nice list sir. How do you find the exhaust note? I’ve only heard mine idle for a brief moment. I’m drilling out the discs because a 5mm hole just can’t be good. I may add bar ends as well. What’s your take on the rear axle sliders? It appears that the non swing arm side doesn’t require a slider, but the other side probably does. Another issue with some rear axle sliders is they don’t have bobbins on both sides to accept a stand, as well as not being able to use the stand that slides into the axle.

 

Thanks for your input I appreciate it. From what I’ve read drilling out the discs has no effect on ECU or low or mid range torque either. It’s supposed to have a deeper grumble at low RPM‘s and at higher rpm’s is unchanged. I will definitely let you know for sure on the exhaust and the stand thanks again.

 

Nope, still waiting. You won’t be disappointed, Pitbull stands are top quality. I have one for the Street and it is awesome. With the bike on the stand you can sit on the bike, hell you could jump up and down on it without a worry. Last night I was going to take the chain guard off but couldn’t, as the wheel has to come off and a stand is needed. Did you get the option with both pins? I did.

 

Nice.

 

Ok, the integrated tail light is on. Went on very easily and works awesome. No more turn signals gives a very clean look as well. Here are a couple of photos and I will try to upload a video if I can.

 

Sorry can’t do the video, apparently the file is too large

 

Sorry can’t do the video apparently the file is too large

yeah, thanks I really like it too. As far as the exhaust goes, it’s just still not quite loud enough

 

A couple more photos I forgot to post of the integrated tail light change out.

 

The rest of the mods are here, a few quick photos then off to install them.

 

Thanks. Yup photos to follow.

 

Ok, everything but the frame sliders are on. Off to get the right size torques for the install.

 

Thanks man. . What is the size of torques bit for the sliders? I thinks it’s a T60. Also what size is the nut behind it? And thanks for the torque setting, I’ll check as well.