Tiger 1050 Adaption Cycle

Discussion in 'Tiger / Explorer' started by DanielB, May 6, 2022.

  1. DanielB

    DanielB Noble Member

    Jan 13, 2019
    887
    393
    Abingdon, Oxfordshire
    Another few hours have passed...so another posting :rolleyes:

    Whiskey, boredom... whatever... scrolling through previous posts...

    What is "the adaption Cycle"?

    What does it do?

    How do I do it?
     
  2. capt

    capt Elite Member

    May 8, 2016
    3,051
    750
    western Australia
    Start your bike , use no throttle , leave it to Run for ten or twelve minutes. Should trigger cooling system fan at least once if water cooled ! Switch off as jobs done !!

    Purpose to allow engine management the "ECU" time to learn the parameters that exists in current local !!

    Useful if for instance , if you move home base from low lying coastal area's to say halfway up a mountain range , say over a thousand metres high....
    ECU does a reset and does a base calibration.
     
    • Like Like x 1
  3. DanielB

    DanielB Noble Member

    Jan 13, 2019
    887
    393
    Abingdon, Oxfordshire
    Excellent, learn something everyday... :)
     
  4. DanielB

    DanielB Noble Member

    Jan 13, 2019
    887
    393
    Abingdon, Oxfordshire
    Is it worth it? Running the adaption Cycle?

    I mean...I live in Oxfordshire...

    The bike's been ridden around all week...
     
  5. capt

    capt Elite Member

    May 8, 2016
    3,051
    750
    western Australia
    It's usually done if you have changed something ! Style or type of air filter , exhaust mod or change of address (elevation)
    .
    Otherwise -. No !
     
    • Useful Useful x 1
Loading...

Share This Page