2017 Evap Removal

Hiya!
I removed the canister first and then the solenoid
Took off the bracket then the hoses to the throttle bodies. Installed the blanking rubbers.
Then, install the plug into where the solenoid was (cable went into a large loom) And switched on. Bike starts fine but has an error now but you just acknowledge it.

 

I haven’t cycled the engine yet. Is that where you start it, and leave it for 12 mins (x3)?

 

Hi joe,
Well, i emailed them and they were no help whatsoever.
Basically, they said that they've never EVER had any complaints and it's my error and to go away.
I pointed out that even the instructions were wrong and they said there were two rs versions. There isn't.
So, as it doesn't stop the bike working, i'll see if the dealer can eliminate the error when it's serviced in september.
So, it's got an error on all of the time with a "check engine" light.
ho hum

 

Its started to work!
I did the cold\warm start thing 3 times and light was still on.
I resigned myself to the fact that a visit to the dealer\ignore it was looming.
Went out yesterday and the light went off when I started it up again !
So, good news!
Looking back at the whole thing, too stressful to recommend to others I think.
As you said , even getting the evap bracket out was a pain. mine had a torx on one side and Allen on the other side.