Separate names with a comma.
Does anyone know where the short hing goes on a 77 seat, front or back?
Found an old 70s seat with the Triumph lettering faded off the back of the seat. Any suggestions as to how I can recreate the lettering or where I...
If you haven't found the fix.....No flashers, Check you grounding. Before you spend a fortune on parts, put a screw driver between the headlamp...
It's a Triumph...... If it were an older bike, I'd start with the plug, then check all the wiring. If still running on one cylinder, it could be a...
1977 T140 Bonnie....Same problem here even with a new harness and new connections. Turned out to be a short (grounding problem). Ran a wire from...
My 1977 has over 40K miles on it and I have changed the oil every 500 miles. Takes 10 minutes on the old bikes. Excessive, well it's still...
If you retire and need something to occupy you mind 24 hours a day, then I would suggest taking the plunge and purchasing that old single...
You Brits call it "Earth" while we Americans call it "Ground." Most of the time I use not Mother Earth (ME) but MF when I am working on my 77...
Found it. As you Brits might say "It's Bad Earth." As soon as I touched a wrench to the turn signal arm and the forks, like magic the turn signals...
When I switch either the right or left, both turn signals come on very dimly. I have traced the wiring through and have not found any problems, I...
I found the problem on my end...
TY
Please explain the numbering system on a spark plug (Champion N3C --- NGK BP6ES) and what effect a higher or lower number will have on a 1977 era...
When trying to set up a new post, I am finding it difficult to find the correct page to get started. It seems it always ask me for members to post...
I saw a vid describing this method with the electrode. I actually used the gravel, nuts and bolts with distilled water method and it seem to do...
Any suggestions on how to clean rust from inside a gas tank.
After hours of screwing around with the nut in the fork tube, I finally figured out that it is not a nut but is the end of a 1/4 inch socket...
Thank you for your reply.... The parts list shows a nut with a parts number but no size indicated. What is UNC or UNF?
That is what I thought. Do you know the size of the nut in the fork... I've done this before and had a fit, but cannot seem to get a fit on the...
Housing needed tightening (ground). All nicely blinking...