Search Results

Will that lever not fit the 2011+ then ?

Already got one mate..... TuneECU showed ( it wasn't super accurate as it went up in 2 degrees sometimes 4 degrees) 1 bar...........33°c 2...

I'll have a look with TuneECU in a bit and report back...

Yeah temp gauge goes up fine letting it tick over stationary... As soon as I'm moving with wind into the rad it drops to about 2 bars I...

Cheers buddy.... I'll have a look at the weekend

Done it mate.... Sat in a layby bike got up to temp fan came on Rode a bit more and it dropped back down to 2/3

No.... If I try to pull away from lights at 2000rpm nice and gentle, ease the clutch out, as it starts biting bike starts moving, give it a few...

Threw in the Arrow slip-on map this morning Rode to work and the results were.... 1 or 2 misfires around 2000 (when using too high a gear after...

Try going for a ride then disconnecting the reg/rec when you get back Leave it a bit Reconnect reg/rec and see if it still has life I had one...

To charge you £100 more for £10 of steel :D If it comes in the Arrow kit then may as well fit it I'm sure SC's fit onto standard pipes so...

I get what you are saying but If I try the Arrow map with a smoother looking F/L switch and it stops then I know the issue is with my standard...

Nosing with TuneECU last night I noticed that the OEM map has a big dip around 2000 compared to the Arrow slip on tune which is a lot smoother.......

It's all built into the coil stick... There's just a little electrical connector to them, no HT lead or plug cap

At £82 each they're getting multimetered first :D

Workshop manual says 0.8 to 1.2 ohms so I'll try them later......

Hhhmmmmm good call.... Do you think a resistance check would show it up ?

Updated TuneECU (Android phone version) yesterday and it said it now can do ABS bleed [ATTACH]

I haven't mate sorry..... It was a throttle tube I bought years ago If you Google 1/5th Turn R6 throttle then loads of forums have the part numbers