Speed Triple Forks

If you went for powder coating you would have to strip them right down remove all seals and then send them in. A lot of work but the best and most resilient finish...
I would get them sprayed & lacquered personally, go to your local body shop they may even do them on the bike......
Last option is Plasti dip.. spray it on and when you get bored peel it off...... simple easy and cheap.....

What ever you decide to do, you have to be aware that where the triple clamps clamp down they may damage any paint on the forks.

 

I think powder coating would be the best way forward it might be a bit of a pain taking it all apart but will give a much better finish, the other options are things like anodizing or painting but you will need to strip the seals etc out for that too.

 

Sorry Screwball I only just read your reply! Basically I agree with you.

 

No problem Spanky...
Thinking about this the cheapest option is a pack of Sharpies......

The bronze is anodised so very little work to rub it down...
Just how much £££ and how far you want to go.....

Black chrome may be a good look actually pretty great I think....but again it's a strip down job....
How much ou want o spend... Painting will be cheapest real world option...after the sharpies and plasti dip of course.....

 

Seriously? I had a brake reservoir cover that had been anodised with a blue dye finish, rubbed at it for ages with wire wool & it didnt even touch it mate. Sandpaper, if it removes the bronze finish will scratch fuck out of the forks which will result in even more graft polishing the scratches out. Nitromors did fuck all either.
However.... Caustic soda crystals with warm water & literally dip it in for seconds & the dye is gone! Leaves it with a dull natural finish which can then be polished up to a brilliant shine....

Anodised blue...

View attachment 1041


Natural finish after 10 seconds in a warm caustic soda solution...

View attachment 1042


A quick bit of polishing with Autosol & buffing attachment...

View attachment 1040

 

Painting could easily look a mess though unless its done properly. Black chrome would look good

 

Anodise is usually used to for its chemicals resistant properties which is probably why it was harder than a whores heart. Never thought of caustic soda crystals though, looks better polished than blue Pig!

 

I wanted a polish reservoir cover but didnt fancy paying £30 for one, got a blue one second hand for £5. The less popular coloured (blue, green, purple) anodised goodies sell cheap as on ebay second hand so you can save yourself a fortune!

 

Top tip!

 

I meant for painting, not too polish it up... You only need a scratch coat and then prep with thinner and Taki cloth to make srue dust & crap are not left on surface.....

 

Painting or powder coating forks is not really how you coat fork legs - and impossible whilst on the bike. They should be anodised. Either way, they have to be completely stripped down. Painting may also cause issues with thickness and will definitely cause issues when clamped back into the yokes as it's a layer deposited on top of the fork legs so sits between the leg and clamps - not good.

Get them anodised. Its pretty cheap and looks best I think.

 

Why not just get a local sign writer / vehicle graphics company to 'wrap' them in vinyl? I'm considering doing it to my Speed - got a good mate who does all my work vans - he's done the bonnet of his new motor and it looks the dogs danglies! :upyeah: