EFI problems?

Hi Bazz, The first thing you need to do is download (for free!!) a program called TuneECU, it's a dedicated Triumph/KTM diagnostic program. Then buy an OBD (OnBoard Diagnostic) cable. Then you can connect your laptop to your bike's ecu to do fault-finding, remapping and loads of other stuff.

Re the cutting out, make sure your tickover speed is 1100 rpm when the engine is warmed up. ALWAYS use the start control (looks like a choke push/pull thing) it's not just for cold weather starting.

 

Here is a place to buy the cable

 

You use the 'start's control every time you start the bike (it has 2 positions plus off, use dependant on ambient temp), then as soon as you ride off (or the bike will tick over normally) push it fully home so it is in the OFF position.

This control is literally only there to start the bike - it's not like a traditional choke where you use it to bring the engine up to operating temperature by enriching the mixture. That function is dealt with automatically by the EFi system.

 

no worries Ive been called worse and its not been by mistake.

when you get your cable, or before, download the drivers from the TTP site to your laptop and install, to your homescreen or somewhere where youll find it easy to locate, before attaching the cable. When you attach the cable for the first time make sure you have wifi turned off. Then it will ask for drivers, search to where you downloaded them to and install.
heres a link that shows tuneecu on a tiger, it'll give you an idea

 

Bozz, once you get the cable we'll hold your hand through the process.

 

With the bike running, just turn the start controller nob, it is stiff to turn and only needs a very small turn to achieve a higher idle setting.

Had to do it to my america otherwise it would cut out when pulling away or even coming off the throttle going down a hill. Since adjustment to an idle of 1100 rpm no issues.

 

Following on from what SB said, you can adjust the tick-over manually but it is done using a knurled knob situated on the same side as the start control and below it.

 

Oops good point, its not the start controller you turn, it is the nobbly dial below it.

Sorry for that, keep listening to biglad

 

Hi Bazz. Having read through all the above on your problem it makes me feel really smug that I stick to my old 07 reg Carbs model instead. It looks like the chaps above will sort you out so best of luck and I hope it works out.

 

just remove the AI and O2 and adjust the tick over up a tad watch this video its the first thing i did when i got my bike and she runs much better with the off use nissan micra sump plugs http://www.ebay.co.uk/itm/NISSAN-MI...:Micra&hash=item27dcca7cb5:g:6pEAAOxy039TMrEG