Triumph Sprint Rs 955i - Fuel Pump Not Priming, No Clicking

Hi Everyone,
I have been lurking around trying to find a solution and came across a few interesting topics but couldn't match all the symptoms with my situation.

I hope that you could spare a moment and guide me in the right direction.

I have Triumph Sprint RS 955i and been looking after it for 5 years now.

When I turn the ignition the display starts as normal.
- The fuel pump makes no whizz sound that was always present before.
- When I press the thumb started there is no crank and no clicking noise.

The following were also checked:
- Horn is working.
- All lights are working.
- Bike is in neutral and green light is showing.
- The Ignition On/Off switch is "On". (Located on the right handlebar with a red switch.)
- I checked the fuses under the seat and all OK.
- There are three square relays (I think they are called relays?) under the seat. One is next to the fuse box and 2 are on the right-hand-side by the fairing. I took them off and gave them the elbow clean.

After fiddling with it for half an hour.
Key in, ignition on. Press the clutch lever, press the thumb starter > no sound. > Ignition off, key out. > key in... Rinse repeat...

It happened a few times that the clicking and cranking came back for a few moments that were enough to start the bike. Once the engine was switched off, and key out the key in, ignition on... ... ...
I couldn't start it again.

At no point, there was a prime from the fuel pump even when the clicking sound and cranking happened later.


I would really appreciate any advice you can provide.
Kindest regards
L

 

Hi Guys, Thank you for the comments and your patience.
My tools were in the car... the car was parked few miles away from where I am currently staying. I managed to get to the car last Sunday. ... and tools were not there.

Today I found Lonelec cable and got TuneECU to work.
No errors found in the system.
Now this is interesting.

When I held the thumb started and started playing with clutch lever I could hear "THE CLICK."
Then I had to release the thump started. Press the clutch all the way, hold it there. When I pressed the thumb started again sometimes the bike turned the engine over. Sometimes not. And I had to fiddle with clutch and thumb starter few more times.

I managed to turn the engine over maybe 3 times, but it seems the battery is weak now. And knowing my luck the battery charger is in the car ;-)

Is it possible for the clutch cable to be worn out or stretched?
I tried adjusting it different ways but couldn't say it helped.

I will keep you posted how it goes, in the meantime any ideas or comments would be highly appreciated.

Have a good one!
L

 

Thank you for the lead.
Just to follow up on the issue.

It's actually the right-hand switch.
The thumb started to be exact.

When the clutch is held in, and the thumb starter is being pressed extremely slowly at some point it will engage and the engine will start turning over.
or
if I use more pressure to press thumb starter it works well.


I am not an electrical guru but would be guessing that something is not connecting properly inside. I would say the wires are good it must be something that closes the circuit.

Can those switches be fixed or do I need to buy a new one?