Thruxton Abba Stand

Apologies if I'm preaching to the converted but this was a bit of a discovery that I thought I should share.

I have an Abba workshop stand that I bought for my previous SV650. When I looked on the Abba website to see if adapters were available for the Thruxton I was disappointed to find that none were listed. Before selling the stand I rang Abba to double check and discovered that the stand can be used by pulling off the nearside dust cover from the swing arm nut and removing the sprocket cover (5 bolts) on the offside. This exposes the opposite side of the swing arm and enables the stand to be used in the normal way with one of their standard adapter sets.

To lift the front I use a small scissor jack with a custom made timber top wrapped in pipe insulation to sit below the frame rails. This set up gets both wheels off the floor in a controlled manner and gives much better access for cleaning, etc. I set it all up today and it worked a treat and gave me chance to oil the chain and clean out the sprocket cover.

The kit Abba supplied is (52) for Triumph Street Triple/R (10 onwards) (2014)

As I say, apologies if this is already known but saved me getting rid of my Abba stand.

 

Be interested to see a photo if you have one as this sounds a good idea and much less faffing

 

Thanks for the detail Half Ton. Neat job there! What did you cut the cover with and did the lacquer finish break away?

 

Impressive work all by hand. Going to look at mine and maybe take your tip of getting hold of one off eBay. Thanks again for the detail.