Daytona 600 Stops Charging

Hmmmm .... surprised nobody's picked up on this one yet.
I hate elastictrickery!

 

How do you know?

 

Just guessing!

 

you can try contacting Clive Wood in Swineshead. He's pretty good with lecktrickery on these bikes.
07752477738

 

need all the details.

 

found;-

Some common reasons are :
1). Load applied to generator exceeds capacity, typically would cause machine to slow down, drop frequency and voltage typically cause exhaust black stacking and depending on the overload and protection settings could cause machine to stall.

2). AVR Voltage gain set too low to respond to load being applied.

3). If AVR feedback is from generator bus VT and voltage dips too far, all excitation could be lost and would typically result in an undervoltage and overcurrent trip.

4). Speed control gain set too low to respond to load being applied.

5). Mechanical issue such as failing turbo unable to provide enough air of high enough pressure while taking on load which will cause machine to slow down and in some cases stall on high load application with sufficient reduction in speed voltage will also lower as well as frequency. In this condition you'd probably also see exhaust black stacking.




6). Mechanical issue such as fuel injection clogged or fuel filters clogged causing the machine to be under fuelled to handle load application and may cause machine to slow down, which in turn would drop Hertz and Volts.

7). There's a whole truck load full of other reasons why this could happen.


From what your saying you know more than I about this.

 

This would suggest to me a fault in either one of the replaced parts, or a fault in the wiring on the bike itself, corroded connectors, a break in the wiring that opens up with heat.

Are there wiring / connectors between the R/R and the stator that were not replaced when these parts were replaced ?

ie :- do they both plug into the loom rather than into each other ?

Is it the same phase that is " faulty " ?

Where is the R/R mounted ? what to ? is the physical connection clean & tight ?

New parts can be faulty did you check them both hot & cold ? Mosfets are static sensitive !!

How good is your DVM ? I suspect the 5v is induced voltage.

 

ive gt same issues all parts replaced and still doesn't hold charge, continuously charge the battery !
im going to be taking the whole bike apart over the winter month to get to everything !

if you find a solution let me know