Separate names with a comma.
I was looking into some Brembo MC´s from Daytona 675R, but I was a bit afraid to get it from ebay.. So I went for the rebuild kit..
So guys, I managed to rebuild the mastercylinder with the OEM repair kit from Nissin. Brakes are now much more progressive than before and overall...
So the service is done. I told my mechanic about all this brake situation and he was a bit surprised, because he has never heard a bad word about...
So today I tried to change brake fluid on the front.. Well I did not spot any bubbles coming out of bike. After bleeding master cylinder I...
So after bit of time I finally took bike for a little spin around. Front brake felt quite good and sharp but then it just started to feel weak as...
Those floaters are free, that I can spin them by hand. Disc is in quite good condition considering they have "ridden" 40 000 kms. But previous...
When the bike is upwards, than the level is below maximum mark.
And if I blocked the rear wheel, is it possible that air would get to the front brakes system?
Hello again guys.. I was just thinking again about the situation with weak front brakes. Is there any chance that air can get from the ABS...
So what you suggest? Tak them off again a clean them one more time?
So I´ve ridden the bike and.. well sometimes the brakes feel very nice and sometimes they feel very week.. depends on situation. Very strange. I...
So Today I managed to strip the calipers. Looked pretty dirty, probably never been cleaned. Pads were changed once. I cleaned the calipers and...
Thank you. Do you know, where the leak could be? I read about master cylinder failure (new piston kit should repair it).˝ Or somewhere else? The...
Haven´t checked the stripped calipers yet. What would that mean, if they are glazed? I have an invoice, that there are installed Brembo Sinter...
Sorry, I did not understand your question. What do you mean by that? If is the fluid at the same level?