Separate names with a comma.
Crankcase breathing? Check your oil level, if it is higher than the norm, it might be spitting some oil into the airbox.
Rainman, you might be able to refit the original side stand stop, have you tried that? I did so for my 2011 T100, when I installed my TEC Parts...
Tons of upgrades on that Bonnie: led indicators front and back, headlight brackets, chromed engine cover, Hagon rear shocks, aftermarket pipes,...
Even Triumph are not quite sure what to recommend. The T100 2011 manual recommends 33/37, but the 2012 manual recommends 33/41. It's the same...
Are those melts definitely on the inside? Just double checking. In either case, definitely take it to the dealer. I have seen headlight melts when...
Hmmm I wouldn't recommend putting water in the fuel tank. You'd have to find a way to completely empty it to save the fuel, and then making sure...
I've swapped my Bonnie's knee pads in the past as well. I took the tank off, and just used a hair dryer. Better if you can get the dryer to the...
By "rotor", do you mean the brake disc? Have you got photos of the "grooves"? I don't think that raised piece of metal is of concern: the pad will...
I carry two 6in Knipex pliers in my pocket, along with a small philips screwdriver and an old blunt screwdriver. It is incredible all you can get...
They have a nasty habit of ridiculously tightening oil filters in garages, mine was nearly impossible to take off; previous owner had done all his...
TEC usually ship a bracket for this. It's fiddly as hell to get the rubbers out of their original location and in that bracket (had to hack at the...
One of the best investments for this bike, man. The amount of time and money I've saved by not having to bring the bike to the dealer every time a...
Cracking read, thanks fellas!
I really would just try to clean the clutch sensor first. It's super easy. It's the round plug that connects to the left-hand assembly. Underneath...
Hey Mally, if it "sometimes works" and "sometimes doesn't", then it sounds a lot like ti could be the clutch safety. It's a plaguing issue for a...