-
This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
-
joe mc donald liked Helmut Visor's post in the thread Motorcycle Security.
Just for info it would appear that TwoTyres have bought Pragmasis and are continuing to supply the quality products they always did ;)...
Jun 18, 2025 at 8:28 PM -
joe mc donald liked Paul Barton's post in the thread Speed Rs Suspension.
Been constantly adjusting my RS1200 springy bits. Has some 9.5kg fork springs kicking about so put them in thinking balance the bike...
Jun 18, 2025 at 8:28 PM -
joe mc donald rated Axou's post
Agree in the thread Speed Rs Suspension.
Hi, what are your settings ? I weigh 98kg, and to adjust my 2019 speedy rs, I had to screw the preload of my forks almost to the maximum...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated GOT's post
Agree in the thread Speed Rs Suspension.
Has anybody fitted a hydraulic preload adjuster to the rear?
Jun 18, 2025 at 8:27 PM -
joe mc donald rated Nixter's post
Agree in the thread Speed Rs Suspension.
I weigh just over 13 stone and the Ohlins sag was spot on from the factory. The compression and rebound were off. I am currently roughly...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated Linx's post
Agree in the thread Speed Rs Suspension.
I haven't measured it properly yet. By eye I'd say there's about 1cm static sag and about the same as your's with me on it. There are...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated Bryan3R's post
Agree in the thread Speed Rs Suspension.
I felt it was too hard hitting bumps, plus at std rear preload there was very little sag, when I had shock service last year sag was set...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated Linx's post
Agree in the thread Speed Rs Suspension.
I'm 11 stone and find the owners handbook recommend settings for Road cock on. I see it says don't adjust the rear pre-load but it seems...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated Bryan3R's post
Agree in the thread Speed Rs Suspension.
I’m about 13 stone and it was too hard for me and not enough sag, I have Arrow low boy system that drops about 6 kilos off, so allows...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated MattChr's post
Agree in the thread Speed Rs Suspension.
Update: much much better now after Harris (suspension specialist) re-checked preload and damping settings, front and rear, after the...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated MattChr's post
Agree in the thread Speed Rs Suspension.
I’m just under 10st (63kg). Rear was unbearable - after preload adjusted, zero compression damping there was still no forgiveness in...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated Mike2105's post
Agree in the thread Speed Rs Suspension.
I was going to post a thread Scott this until I did a search and found this one. I’ve played with my settings quite a bit. Mine was...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated SuperHans's post
Agree in the thread Speed Rs Suspension.
I find it odd that dealer says that sorta crap (but not surprised), the manual states pretty clearly recommendations of different...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated OhCrumOn's post
Agree in the thread Speed Rs Suspension.
I've had to tighten it up a bit from the factory settings despite my dealer saying I shouldn't have to change anything. It was wayyy...
Jun 18, 2025 at 8:27 PM -
joe mc donald rated Bryan3R's post
Agree in the thread Speed Rs Suspension.
Don’t assume manufacturers set up bikes properly, just look at the crap set up on an MT09, or most Kawasaki’s with too hard spring and...
Jun 18, 2025 at 8:27 PM