Separate names with a comma.
It's the same as on a car water pump, there is usually a tiny amount of coolant that escapes between the shaft bearing and the housing as it heats...
It's the "weep" hole for the water pump.
You don't have to remove the tank as mentioned above. Undo the bolt at the rear, move the tank back slightly and lift the rear.
There is supposed to be oil in there. It does not affect the sensor for the PU coil.
I installed a Motone riser on my 2024 T120 and the cables are long enough. If not, then re-route them to the other side of the fork leg.
Have you considered...
Like this you mean?[ATTACH] Canadian pricing.
If you PM me with your address, I can make a template for you and mail it to you.
Can you show the wiring diagram? The "position" light is likely the parking light if you have that on your ignition switch.
Start with the easiest remedy first. There are "rebuild kits" available that includes the O ring for the bowl and other seals. An ultrasonic...
Keep in mind that it uses a decompressor on one cylinder to assist in starting.
It is likely that your idle jet(s) are blocked. This is the smallest jet in the carb and blocks easily if the bike has been standing with fuel in...
I have a pair if you want to PM me with an offer. I don't know where you are located so I can't give you postage cost.
These are indeed JIS screws indicated by the small dimple on the top. If using the correct screwdriver doesn't shift them, then get a very sharp...
