Triumph Tt600 Engine Swap

Hi, recently swapped out my engine for a second hand one (original engine had no compression on cylinder one and was burning oil and water)

The replacement engine will start but then stalls out and won't start for a while, thinking fuel but a bit lost, (even considered trying to swap the fuel cables around as they had no markings on them and wondered if they were on backwards, although I believe they're correct, right hand pipe to red connector)

All cables are connected (I believe correctly) apart from one air pipe running to the airbox which has a 'T' coming off it I can't work out where it goes, (see pic)

Any advice gratefully recieved

 

Just run tune ecu, came up with no error codes, run for 10 minutes on tickover, as soon as I gave it a blip on the throttle, it accelerated (slowly, like there was a lag) when I let the power come off it cut out?

 

Hi, Cheers for the repky, yes there is one of them, but this pipe runs from the airbox to the ecu at the back of the bike, but has a T joint about 6 inches from the airbox, I really can't see what it joins too?

 

No, just doing some reading it appears I should reset the TPS is this the same thing?

 

Just read up on it, will sort it tomorrow, thanks for the assistance, this is my first efi engine and I didn't think I'd be using my balancer on it, cheers max

 

That's cool, I've got a set of balancers, thought those days were past with no carbs on the bike, oh well, will sort it tomorrow, thanks for the info, will post up how it goes

 

Thanks for all your help, balanced and reset tps and it's running like a dream

 

Thanks for all your help, balanced and reset tps and it's running like a dream

 

Thanks for all your help, running like a dream