Advice Needed On Suspension

Is it new or could the previous owner have adjusted it?

 

You can do it yourself measure from a fixed point with the front wheel off the ground then let the suspension settle under its own weight then measure again the difference should be about 15mm(sag) for the compression sit on the bike and pump the forks they should return to the first position and no more change the top adjusters to eliminate any over shoot, rebound is the third and a fine art set the adjuster to the centre setting and ride the bike on your favorite road feeling what she does dial the rebound to suit your style and most used roads hth the rear can be done the same.
hope it makes sense recalling form memory and a bit pissed at the moment

 

Just loosen the compression damping and pump the forks for a base line on if it's improved. Before anything note the current settings. It's possible previous owner changed fluid or put too much in or had resprung

 

How heavy are you?
If your at the lighter end of the scale then a lighter weight fork oil say sae 5 might make it more suitable and plusher.

 

Sounds like you may need less preload and compression damping. I whent to comfort settings on my R, and also broke the law and wound the rear preload adjuster all the way out!

Aim for 10-15mm of static sag and 35-40 rider sag sat on bike in riding gear.
Put a tie wrap round one of your lower fork legs and slide up to dust seal, this will show how much suspention you are using, then you will know what way to adjust your preload.
You want to be getting full travel under braking without bottoming out. like mine below.
Untitled by Bryan Haynes, on Flickr
Check out Dave Moss Tuning and Two Clicks Out on Youtube.

 

Is it an R with Ohlins?

 

They do have harder suspention, what's your weight?
I'm on comfort settings and I'm 12st 5lbs, but its still a bit too firm.

 

Sag setup

 

It’s all fairly simple once you know where you suspention is and where you neee to be.

Had a look at one of your threads, your bike not got Ohlins on it.
Isn’t it a 94 non R? If so it’s springs rate would be softer than the Ohlins set up.

 

Hi Speeder, i'm in Bournemouth if you are passing by i am more than happy to go through suspension set up with you.

 

I would check your bikes settings are at the standard settings.
Preload. start by winding all way out anticlockwise (least preload)
Compression and rebound damping, start but winding both all the way in clockwise (most damping)
Then go to base settings in owners manual.

 

I have the factory settings if you want them

 

I just reread this, and to be clear, you want a total of 35-40mm of sag. This is achieved by adding the static sag to rider sag, for a total sag number of 35-40mm. With the same sag number front and rear of course.

 

There are very few people get there suspention serviced, once its done about 6,000 miles the oil is no good. But reguardless you need to get your set up on warm oil not cold this time of year.
I was fortunate that my bike has a leaky fork seal when bike shop took it in on PX, so had now seals and oil b4 I collected it, will be having shock service and possibly softer spring later this month.

 

yes, but you must have the static sag.

I had to add some preload my front to match the rear (wound preload rings all the way out) which is a bit too firm to balance the bike out until I get the spring swapped for a softer one.