Sprint Tank Grips

Good idea... When I had a black Street i got some Black vinyl (as used for car graphics) and did the same thing.

 

Venture shield is also cleaver stuff, almost invisible and protects against stone chips.

 

I tried Venture shield on my GSXR... Triumph do it as a kit.. Very good but I could not use half of the kit I had as my clumsy fingers struggled to fit some of the more complex bits......

 

I professionally fit it. The trick is to make sure all polish is removed from bike. Warm bucket of water & johnsons baby shampoo. Cut all the pieces out and submerge them in the water whilst removing the backing once they're wet your finger prints won't show and you just slide them into place and dab until they have set. For real tricky places just keep rubbing and rubbing until it sticks.

 

CC i did the easy bits and then lost patience... tried to fit the fiddly bits failed and then thought sod it...
BUT it is very good and does what it says on the tin...
Was thinking about it for the side of my tank coz of the ghosted in Union Jack... But i think my legs hit the carbon tanks panels i got from you so hopefully i wont wear the paint..

 

Just warm it up with a heat gun or hairdryer to soften the glue & it should peel off easily enough.

 

Bring the dulled paint back to life by mopping it with some Farecla G3 compound & finish with a decent polish to get it gleaming like new again. The G3 will cut out any fine scratches too.

 

I second that G3 and G10 (G10 is just a finer compound) awesome stuff for bringing paint back to its best and getting rid of the small marks. :upyeah: