Mirror Moving About

Could it be glued/set into position??

 

If there is a metal type cup? around the ball part of it?
You might be able to tighten this by carefully tapping it tighter with a punch

 

Go back to the dealer and keep quiet about the helmet rack

 

Have you tried turning it a few revolutions to see if it will self tighten ? certainly worth a go.
Failing that, it sounds like you will have to take the glass out and see how it has been assembled.
Could try a bit of 2 part adhesive without using the hardener, it gives a gluey sticky condition which may hold it in position and stop vibration, but would allow adjustment.

 

I'm waiting for some bonneville bar end mirrors to be delivered from World of Triumph . Reading the fitting instructions in advance I see there is a grub screw inside the two " halves " of the mirror fitting. The screw is set for tension before the outer bolt is tightened down. This allows for minor adjustment while riding. Not sure about speedy mirrors but could the screw be loose if they have the same tightening arrangement ?

JJ

 

I've got the same problem, let me know what solution you come up with, took it to triumph their solution was glue! Don't really want to do that as I tend to swap bike alot when out riding.

 

lol so order a new one then,job done

 

If I remember rightly, there could be a spring inside the curved area to keep tension on and a nut. Could the glass part be popped out for access to the inners? Sort of thing I would do but it would require a good bit of skill.

 

On another note, one of my motortrade tricks was if I got a car to sell with a sloppy gear lever I'd pop out the lever from the nylon ball and socket an wrap a 'cut off' from a nylon sand bag round the ball and stick the thing back together. It made the movement nice tighter and smooth.
There may be a way to lever the ball on the mirror over to put a slither of a nylon bag in to tighten the joint?

 

The way to cure the problem is to use a auto center punch on the steel ball, you move the mirror to its extreme and make 2/3 punch marks. This will expand the steel making the mirror tight.

 

May only cure it temporarily though, hopefully there is a grub screw like Johnjo referred to.

 

This will sound strange and no I don't use the product, it's my daughters .

Try spraying hairspray into the joint of the mirror, while moving it around. Then set it to the position you like.

I did it this weekend and now the mirrors don't move at speed. I'm not sure about rain if it will remove the hairspray, but then just reapply.

Just an idea. Cheers.

 

What about Thread Lock set the mirror remove and apply.

 

Loctite make a "wick in" product, a drop should do it !