America Corrosion Question

Less than a year old you say?
I'd say it's got to be down to being neglected after being ridden on salty roads over the winter.
I have a 2005 Speedmaster and it is showing very little corrosion. I don't ride salty roads at winter.

I've amended the post with the words in bold (I'd missed the words out of my original post)

 

Unfortunately from what I've seen and read of various forums the quality of materials and the quality control on assembly seem to be less than on the earlier models. My 02 America's finish after 15 years is still in very good condition, bit of a shame really as the Triumph marque has been growing well with an ever expanding model range.

 

Less than a year old you say?
I'd say it's got to be down to being neglected after being ridden on salty roads over the winter.
I have a 2005 Speedmaster and it is showing very little corrosion. I don't ride salty roads at winter.

I've amended the post with the words in bold (I'd missed the words out of my original post)

 

Put away wet ! Simple as that. But it's not the end of the world, when I bought mine, even tho' only 1200 miles on it, there was a fair bit of surface corrosion on the wheels and the chrome sissy bar. My guess was put away wet and left till he could be arsed to sell / swap it!!!

Took a bit of elbow grease, autosol and swearing, but can be cleaned up fairly easily. A lot easier with the wheel out, and worth the effort rather than struggling to get at it.

Had a look, it does look noticeable, get £500 knocked off or they get it sorted first! !!! Seems a fair chunk of money for it, so should be right. Or just factor in £50 to get it polished.

 

just seen engine fins, some tosser has not looked after that bike !!!!! It is all sortable, as the surface's are all bare alloy, wheels and fins, but not for top money from a dealer!!!!

 

Good advice mate, if he's too slack to even clean it how slack has he been with the maintenance and servicing as well.

 

What's the best way to maintain the engine fins in good condition?

The left hand side on my Speedmaster is getting a little corrosion on the fins

 

First cleaned it up using 800 wet and dry, a block of hardwood (to keep it flat) and WD40/GT85 as the 'wet'. Then sprayed in ACF50, corrosion has never come back.

 

That could just be muck! Mine looked worse after 600 miles up to Aberdeen and back! Muc-off, and a wheel brush had them shiny soon after.

But the bare metal finish is not brilliant, if a big issue, factor in £100 to get them powder coated silver ? That was my intention, but to be honest. Once cleaned and coat of ACF50, they clean up OK at every wash.

At least not lacquered, once water under, that does look a mess.

 

Thanks MrOrange, I'll get that sorted!