Speed Triple -06 Maintenance

Discussion in 'Speed Triple' started by Barrelrider71, May 31, 2021.

  1. Barrelrider71

    Barrelrider71 New Member

    May 25, 2021
    3
    3
    Scandinavia
    Hello!

    I'd like some advice on maintenance as I want my triple in good condition.
    The bike has about 18600 miles (30 000 km) on the clock and runs great. I have the manual and plan on doing the following:

    - Oil and filter change
    - Air filter check/change
    - Regrease steering head, linkage and rear wheel bearing
    - Change brake fluid and coolant
    - Fuel filter

    Would you call this sufficient or is there anything else preventative I could do? Like balance the throttle bodies?

    Best regards Jesper
     
  2. Bolosun

    Bolosun Senior Member

    Aug 25, 2020
    276
    113
    Crewe/Cheshire
    Fork oil and throttle bodies
     
  3. Yorkshireman

    Yorkshireman Crème de la Crème

    Dec 12, 2015
    3,400
    1,000
    Barnsley
    Just be mindful that if there isn’t a lot of grease in the steering head bearings when you undo the top yolk nut and lower the stem you are likely to loose your balls :eek: and if some go into the frame tube they may disappear forever and you’ll then be faced with the possibility of replacing them with taper roller bearings.
     
Loading...

Share This Page