675 New Carbon Bits

I found a carbon fiber company in Canada and there prices are pretty good so I ordered some small pieces to see about quality and fitment.

I got a set of heel plates. They look good and they are nice and thick which is good since they do get pressure applied to the from riding. I did have to open the holes up about an 1/8" so that the stock screws fit. Other than that the mounting holes match up.





I also got a set of tank guards. Again quality is great and they look nice. They do seem a little thin to me, more for cosmetics than protective. They didn't send any type of adhesive so I had to run out to old wally mart and picked up some 3m double sided tape for auto molding. Cleaned the area with alcohol and slapped um on.





I will now start to add more pieces down the road to make my Rx stand out.

 

Got these today...



Look at the difference in the huggers size.



Installed...

 

Postman dropped off these new bits. Front fender and the two side belly panels. Fit was great as well as finish. Gonna get 3 more pieces to finish off the bottom half. Lower chain guard, sprocket cover and reservoir cover.