Had my Street Cup for 6 months now and super impressed with it. Hopefully made some subtle changes, which are included in the attached photos. Need advice on a scissor jack, as these models seem to have the sump slightly lower than the frame rails!!! All advice welcome. Regards Mark
These are what I used to use to lift my Street Cup when I had it... Primarily this: https://www.tecbikeparts.com/produc...ddock-stand-bobbins-axle-adapter-bobbins-kit/ And I'm pretty sure I also used my lift, which I've also used for my Bonneville and Bobber: https://www.amazon.co.uk/SwitZer-Hydraulic-Motorcycle-Castors-workshop/dp/B075WZJNK9
Cheers, got the bobbins from TEC but wanted a way to lift both wheels at the same time. The hydraulic looks good, but a scissor jack is the same principle. unfortunately both contact the frame/sump exactly the same, so was looking for a lift that has something to prop under the frame rails on either side. Hope that makes sense. Cheers
The overall width of the supports on the lift is 30cm with a gap between of 17.5cm, which I believe was sufficient to allow for the frame rails to sit on the lift supports whilst missing the sump. But my memory being on par with a goldfish, I can't say for certain that I did use it on the Street Cup, but I certainly used it on the Bobber which had a similar issue with the frame rails and sump.