Master Cylinder Rebuild + Stahlbus Bleeder Valve

Discussion in 'Technical Help' started by Hubaxe, Jul 19, 2021.

  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  1. Hubaxe

    Hubaxe Good moaning! aka Mr Wordsalad :)

    Mar 25, 2020
    1,718
    800
    Aix Les bains - French Alps
    Hi,
    Here is a feedback about rebuilding my Sprint ST 1050 master cylinder.
    I purchased a Nissin rebuild kit for around 25 euros.
    1- bleed to empty the MC
    2- remove the MC from the bike (Very easy)
    3- remove the lever
    4- remove the clip. that's the guess work, moreover without the special plier. To remove the clip, the piston need to be held pushed. With some patience it's not impossible. If I have to do it again, I will purchase the correct clip remover plier.
    5-clean the MC, with fresh dot "oil" the new piston.
    6-put everything together.
    C31C1E2F-23E9-4FBF-BFB4-DAD658B08AEC.JPG

    I took advantage of that work to try those Stahlbus bleeding valve.
    It's basically a caliper bleeding valve with a built in pressure valve.
    It's a bit pricey (25 euro each), but very efficient.
    Unscrew 1/2 turn, put your waste tube on.
    Press the lever and you don't need to take care of the bleeder.
    It makes brakes bleeding so easy.
    IMG_2920.JPG
     
    • Like Like x 2
Loading...

Share This Page