About to prep my tiger 955i engine for a partial repaint. After some advice on the correct process. Looking a e-tech heat resistant enamel. Is an etch primer advised with this or not.
Thanks for your reply I will go with that. Are there any you would recommend? A brush on one would be preferable
Never seen or used brush on, i use u pol acid etch and you can get it in aerosol. you only need to spray it on lightly as one coat does it.
Thanks to all who replied to my post. I am going with u-pol 8 acid etch primer suggested with an e-tech high temp enamel coating. This project is going started when the weather warms up a bit. Will up date when complete.