'02 Speedy - dash dead, starter button does nothing

Discussion in 'Technical Help' started by Duncan Mackie, Jan 6, 2017.

  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  1. Duncan Mackie

    Duncan Mackie New Member

    Sep 23, 2016
    0
    1
    Edinburgh
    #1 Duncan Mackie, Jan 6, 2017
    Hi all,

    Went to start my '02 Speedy yesterday after around 2 weeks in the garage and found that the dash did nothing when the ignition was switched on. Lights, horn, signals etc all work fine but the starter does nothing.

    At first I thought it was a flat battery so I left it on charge overnight, multimeter shows 13ish volts so should be OK there. All fuses intact, have checked the wiring for the ignition switch, dash etc, all seems alright.

    I'm at a bit of a dead end here, bought this Triumph after owning an extremely unreliable KTM hoping it would be better, but have been a bit disappointed thus far.

    Any help or comments appreciated!
     
  2. steve lovatt

    steve lovatt Something else

    May 12, 2014
    9,242
    1,000
    North Yorkshire
    #2 steve lovatt, Jan 6, 2017
    Have had this problem a couple of times with my Bonneville. All lights on, instrument sweep, fully charged battery etc but press the button and not a sound. I just kept trying (about 5 times) and it fired up and has not done it since - so I've no idea what caused it or cured it either!
     
  3. Duncan Mackie

    Duncan Mackie New Member

    Sep 23, 2016
    0
    1
    Edinburgh
    #3 Duncan Mackie, Jan 6, 2017
    Thanks for commenting. On mine the digital readouts and backlights do nothing, usually when you turn the killswitch to 'off' it turns off the dash too, but in this case it stays off regardless off what position the killswitch is in.
     
  4. steve lovatt

    steve lovatt Something else

    May 12, 2014
    9,242
    1,000
    North Yorkshire
    #4 steve lovatt, Jan 6, 2017
    Could it be a loose or dirty connection somewhere or a bad earth?
     
  5. Sprinter

    Sprinter Kinigit

    Aug 17, 2014
    5,995
    1,000
    uk
    #5 Sprinter, Jan 6, 2017
    clutch lever side stand? Check.
     
  6. capt

    capt Elite Member

    May 8, 2016
    3,051
    750
    western Australia
    #6 capt, Jan 6, 2017
    Loose or dirty connection, is/was it very wet/damp during the two week lay up ? Water may have ingressed it's way into the wiring at a coupling/connector.
     
    • Like Like x 2
  7. steve lovatt

    steve lovatt Something else

    May 12, 2014
    9,242
    1,000
    North Yorkshire
    #7 steve lovatt, Jan 8, 2017
    The same thing happened with the 5amp fuse on my old T100
     
    • Like Like x 1
  8. capt

    capt Elite Member

    May 8, 2016
    3,051
    750
    western Australia
    #8 capt, Jan 9, 2017
    I would check behind dash panel headlight area first !
     
  9. Sprinter

    Sprinter Kinigit

    Aug 17, 2014
    5,995
    1,000
    uk
    #9 Sprinter, Jan 9, 2017
    can you short the starter just once to see it it is working then that localises the problem to the dash and starter button and they must share some connectors. do you have a manual to see wiring diagrams the ignition connector is under the head on the right tucked in. Please do not think I know what I am saying.
     
  10. Duncan Mackie

    Duncan Mackie New Member

    Sep 23, 2016
    0
    1
    Edinburgh
    #10 Duncan Mackie, Feb 17, 2017
    Problem seemed to alleviate for a few weeks but has started again now. :( Same symptoms as before but the fix I used before is no longer working. I'm on the verge of punting this bike as spares and starting afresh - I bought it hoping it would be reliable in comparison to the time-bomb of a KTM I owned before but so far it's been just as much if not more trouble.
     
  11. anthony gothard

    anthony gothard Well-Known Member

    Mar 2, 2016
    114
    93
    lancashire uk
    #11 anthony gothard, Feb 17, 2017
    Just a thought.
    i have intermittent issues with my speedy too.....mine turns out to be the datatool alarm / immobiliser. wonder if you have one fitted ?
     
  12. Duncan Mackie

    Duncan Mackie New Member

    Sep 23, 2016
    0
    1
    Edinburgh
    #12 Duncan Mackie, Feb 17, 2017
    Cheers for the reply! Yes - I do have the Triumph Datatool S3 alarm fitted but I'm not sure if it has an immobiliser function. I've tried the bike with the alarm unplugged and the 'blanking plug' fitted in its place. Still no luck with it. :mad:
     
  13. Sprinter

    Sprinter Kinigit

    Aug 17, 2014
    5,995
    1,000
    uk
    #13 Sprinter, Feb 17, 2017
    kill switch?
     
  14. Duncan Mackie

    Duncan Mackie New Member

    Sep 23, 2016
    0
    1
    Edinburgh
    #14 Duncan Mackie, Feb 17, 2017
    Tried it already. Took it apart, cleaned and reassembled and continuity is all in order. Cycling the killswitch makes a relay under the seat click but does nothing other than that.
     
  15. Sprinter

    Sprinter Kinigit

    Aug 17, 2014
    5,995
    1,000
    uk
    #15 Sprinter, Feb 18, 2017
    Did you ever check out the battery fully ?

    can you swap out the relay?
     
  16. John Will

    John Will Member

    Dec 5, 2016
    43
    18
    Bury St Edmunds.
    #16 John Will, Feb 19, 2017
    Check Datatool web site as they have a recal on the red and Triumph ones. .
     
  17. anthony gothard

    anthony gothard Well-Known Member

    Mar 2, 2016
    114
    93
    lancashire uk
    #17 anthony gothard, Feb 19, 2017
    took mine in to dealers on saturday for an engine case replacement. work done, got on bike to come home....nothing, all lit up on dash just absolutly nothing on the turn of the key.......I do have a replacement on order through the recall but ot arrived as yet... bike was pushed back into workshop, was def the alarm, soon as it was by passed it sprung into life.
    Got me home and been fine since, just no protection on the bike at the moment
    certainly sounds the same issue as mine. hope you get sorted soon
     
  18. jagryan85

    jagryan85 Member

    Feb 11, 2017
    7
    8
    Wirral, Merseyside
    #18 jagryan85, Feb 21, 2017
    If it is so easy to bypass the alarm/immobiliser just by unplugging it and fitting the blanking cap it makes me wonder what the actual point of it is. Why they don't just make it built into the ECU with a chip key is beyond belief!
     
Loading...
Similar Threads - '02 Speedy dash
  1. Dyldo

    Newbie Advice - Parts - '02 America

    Dyldo, Jul 6, 2024, in forum: America, Speedmaster & Rocket
    Replies:
    4
    Views:
    1,655
    joe mc donald
    Aug 24, 2024
  2. ChasChas

    L/h Footrest Hangar '02 Speed Trip/daytona

    ChasChas, Sep 17, 2020, in forum: Wanted
    Replies:
    1
    Views:
    768
    Captain Trips
    Sep 25, 2020
  3. rikki d

    '02 955 Daytona Ce

    rikki d, Jan 24, 2020, in forum: Technical Help
    Replies:
    6
    Views:
    1,808
    freck
    Jan 27, 2020
  4. Wire-Wheels

    Old Tank Badges On '02 America

    Wire-Wheels, Jan 23, 2020, in forum: Triumph General Discussion
    Replies:
    2
    Views:
    971
    Wire-Wheels
    Jan 23, 2020
  5. Wire-Wheels

    '02 America Headlight Switch

    Wire-Wheels, May 21, 2019, in forum: America, Speedmaster & Rocket
    Replies:
    4
    Views:
    1,612
    Wire-Wheels
    Jun 21, 2019

Share This Page

Sign up