Separate names with a comma.
https://www.ebay.co.uk/itm/284878528669?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=qduwzHkQTWC&sssrc=2349624&ssuid=qduwzHkQTWC&var=&widget_ver=...
Just sharing this here in the hope it helps someone! I ordered some metal couplings from Tom Parker and had this really generous and helpful email...
Hi there...as per the title really. If I leave the bike on idle for say 10 minutes or so, it just suddenly turns itself off. It doesn’t fade, more...
I’ve heard of people fitting non-standard rear tyres and getting better handling from doing so. I need to buy a new rear tyre, so any advice would...
When for example it says 4cm of free play, which of the below examples of measuring is correct? In image 1 the chain’s movement is through a 4cm...
I need to buy a cable for tuneecu to check the throttle bodies, but otherwise a good start. Forgive the exhaust blowing where the down pipes meet...
I have a pristine painted tank which actually fits, and only has blisters underneath and on the ‘sump,’ zero are on show! Lucky I know! Plan is to...
Well that’s a bit of bad luck...turns out the screw I bought for the drive gear cog is too big at M6 x 14mm. I hadn’t realised the M5 x 10mm of...
As per the title, one leftover connector, that has grease and grime in the terminals, making me think it was never connected to anything in the...
Could someone tell me where the three tank hoses terminate on the UK spec model? My tank was removed by someone else - there is only one...
Hi, any thoughts? Haynes says: 10Nm Triumph Service Manual says: 15 Nm for the short bolts and 25Nm for the 2 longer bolts. Quite a difference!
I noticed the drive gear/cog behind the clutch basket had a small amount of play/wobble on the splines. I had to drill and use an extractor to...
I can safely say that the intake valves get tight, because 5 out of 6 of mine (Triple 955/595) have zero gap. However, is this also the case with...
Two questions, really: Firstly, I sent my T595 head off for pressure testing...would they have needed to remove the 2 plugs as part of the...
SO...bit of a problem...when lapping in the valves I lost focus (talking) when cleaning up the valves from one cylinder after grinding, and have...
Hi there, there must be a simple way for this procedure to happen that I can’t immediately see? Situation is: - Head is off - Inlet calculations...
The NEXT saga! Today I attempted (between showers - this is an outdoor project :D) to remove the liners using the below contraption with a couple...
I have a ‘97 T595...what oils are you using? What’s the general consensus on this oil at £11/ltr? “Shell Advance 4T 10W-40 AX7 Motorcycle 4...
I’m just about to rebuild the head of my T595, which might take a while with various other projects going on. So, I’m wondering, in view of a...
So I’m thinking a DIY head clean of my aluminium head...I’ve heard of full submersion in coke, would this work, will it damage the journals/valve...