Search Results

I installed a Motone riser on my 2024 T120 and the cables are long enough. If not, then re-route them to the other side of the fork leg.

Have you considered...

Like this you mean?[ATTACH] Canadian pricing.

If you PM me with your address, I can make a template for you and mail it to you.

Can you show the wiring diagram? The "position" light is likely the parking light if you have that on your ignition switch.

Start with the easiest remedy first. There are "rebuild kits" available that includes the O ring for the bowl and other seals. An ultrasonic...

Keep in mind that it uses a decompressor on one cylinder to assist in starting.

It is likely that your idle jet(s) are blocked. This is the smallest jet in the carb and blocks easily if the bike has been standing with fuel in...

I have a pair if you want to PM me with an offer. I don't know where you are located so I can't give you postage cost.

These are indeed JIS screws indicated by the small dimple on the top. If using the correct screwdriver doesn't shift them, then get a very sharp...

Does your yoke have the four bolt holes?

Thanks, I was looking for the ones with the rubber insert.

I couldn't find the photo of your footrests, I might be interested.

I tried to upload a photo but it says that the file is too large. You can PM me if you are interested.

I have a RH one that should match, unfortunately there are a couple of scratches on the back of it. I also have a pair of the oblong ones but once...

I should have asked earlier, when the bike cuts out, does the starter still work? If so, then the clutch. side stand and cut-out switches are all...

Good advice there.

If you suspect the sidestand switch, you can find the connector for it and jumper the connections on the harness side. There is another way that...

It sounds like it is electrical, did you check to see that when it cuts out and the engine is still spinning if the tach drops to zero? Check all...

If you have changed the PU sensor and the coil, then the ignition module is the likely culprit. Do you have a tach on your bike? If so, look at...