Separate names with a comma.
Thanks for the Reponses. The attached/enclosed picture should show why it's been tuned to the Ramair filter fitted in place of the airbox. This is...
Thanks for confirmation.
Nope...running great. A show bike in fact so was properly set up by previous owners. Its running a Ramair filter due to nature of the build,...
Recently acquired a most excellent CRK Roadster based on the Trophy 1200 4 cyl. Which variant /part no of carbs are fitted to this bike. Just...
After running the bike for a good few weeks I decided I would look at making some minor adjustments to the pilot air mixture screws to remove the...
You adjective of a "stumble" is exactly how I would describe it. Its carb engine BTW. I set up carbs as per jenks bolts performance and pilot is...
Have been riding the Bonnie for couple of weeks now. It is running great except it occasionally cuts out. This happens when idling e.g. at traffic...
Advice once again heeded. So, will probably just go with the snorkel removal/mod as per TTP. Have not researched yet but is the internal baffle...
When weather is more conducive to pulling plugs at the side of the road l will be doing a plug chop check to see how its performing in its current...
See also my Pick up coil thread. Break in this bleak Blighty weather and managed the dreaded test ride. Bike runs superb! Guessing it was a...
See also my TPS thread. Well, there's an old saying "90% of carburetor problems are electrical" So after completely replacing my ignition...
Oh...seems like you had mixture of problems. Re the TPS, I have one fitted on my Yamaha derived Bobber. Going back through old notes on that I...
So, if you can recall, what was the cause of your misfire/rough running? Fitted tank and popped couple litres fuel in and seems leak free. So all...
Well...tank has been sitting all day with cleaner in it and "regular " agitation as per instructions. Rinsed and blown dry. Nice and clean inside...
Great. Will plug TPS back in then and see how it goes. Thanks Callumity!
Ok...So had some more time and checked out TTP advice on resistance setting of TPS. Fiddly to say the least! Readings were blue to yellow wire...
Assembled carbs in clean environment. Set up and installed. I love how easy it is to install and remove the carbs. Set up my workshop fuel tank,...
Used the Ultrasonic Cleaner for the first time. Very good results. Invested in a cheap compressor too, to make sure all passageways are clear....
I am sure there are far more technically qualified forum members who can answer this but I believe its something to do with emissions? More...
T100 865 carb Bonneville. 2006 year