Separate names with a comma.
Hi Joe. Iowa is a friendly state. We all seem to know each other one way or another. I have bikes with throttle cables, and now one with throttle...
So I went through all the entire wire harness assemblies and verified connections and routing. No issues were evident. I did the calibration task...
I just recently read in another forum that another rider that had the same issue was told by dealer that it was a bad twist grip switch ground. i...
Thanks Joe. I have gone over all connections from the twist grip to the ECU. All connections are solid and all wire harnesses wring out good when...
Is there anyone out there with any experience with this issue?
Went out for a quick ride on my 2017 Thruxton. I have a little over 8,000 miles on it. I pulled over because I wanted to take my wallet out of my...
I think the whole issue started because of a defective oxygen sensor. To take care of that issue, I replaced the oxygen sensors with an oxygen...
As much as I'd like to dyno it, I'm not able to do that as I live in a small town in the Midwest, and don't know of anyone in the area that might...
Sent away to England to get the oxygen sensor delete kit that consists of sensor block-off plugs with resisters that plug into the wiring harness...
I was able to download the shop manual. I went through the entire throttle and throttle control system. Everything checked good to include all...
So far everything I have tried to fix the high idle issue on my 2017 Thruxton has failed. Just to remind anyone reading this, on the 2017...
I bought the DealerTool for my 2017 Triumph Thruxton 1200. I am still having higher than normal idle issues when the bike is cold or hot. I would...
Okay, here is what I know so far. I was able to download a shop manual, and used it with my DealerTool. Using the manual, I Ohmed out all the...
The item Brown Mouse described is what I have. I have discovered that it is not known as a TPS (throttle position sensor), but is actually known...
I took the throttle apart. The white ring inside that the hand grip engages seems to be fine looking at the exterior of it. With the TPS ring...
My bike is throttle by wire. The ECU takes care of all the choke/enrichener functions of cold start. There are no knobs or set screws to adjust...
Is the throttle postion sensor TPS in the handgrip, or down near the throttle bodies?
On first start from cold, RPM goes straight to 3,000 RPM and stays there for a long time. When fully warmed up, idle drops to 1,400 RPM. Should be...