Search Results

[ATTACH] [ATTACH] Which bike and what year does this seat fit?

1977 Bonnie....Okay so I am getting old. A thought came over me the other day that may be, just may be I installed the rear axle backward, or will...

Front wheel hop... 1977 Bonnie 42K on the speedometer... OKay, I am at whits end. Have done the following: New tire and tube (Dunlop K81),...

1977 Bonnie front wheel. Mounted a new Dunlop K81 and tube over a year ago. Bike was stored for shipping for one year in garage. Now that I am...

When changing a front tire, the motorcycle shop did a job on my dust covers with their tire jig. The retainer clip was broken off and the dust...

What effect will 110 Octane Leaded Fuel have on my 1977 Bonnie with the original engine intact? Will mixing this fuel with 93 Octane Unleaded...

How does the primer tickle cap stay on the shaft....

T140V....1977....Bonnie......Is there an easy way to change the primary chain with removing the stator and clutch?

Is there an easy way to change the primary chain without removing the stator and the clutch?

My tach jumps all over the place....Any suggestions as to how I can fix or suggestions for replacing my RMS 3006/00 Smith Tachometer. Is there an...

Found an old 70s seat with the Triumph lettering faded off the back of the seat. Any suggestions as to how I can recreate the lettering or where I...

You Brits call it "Earth" while we Americans call it "Ground." Most of the time I use not Mother Earth (ME) but MF when I am working on my 77...

When I switch either the right or left, both turn signals come on very dimly. I have traced the wiring through and have not found any problems, I...

Please explain the numbering system on a spark plug (Champion N3C --- NGK BP6ES) and what effect a higher or lower number will have on a 1977 era...

Any suggestions on how to clean rust from inside a gas tank.

There is a leak in one of my front forks. I pulled the wheel and checked the Allen wrench fitting inside of the bottom of the forks. One was tight...

1977 Bonneville: Is there a way to clan the main jet in the carb without removing it? Can it be removed without the special too?

My 1977 Bonnie only fires on one cylinder, the right. I have switched (left side) the plug wires, condensers, coil, plug wires, plugs, new points...