Separate names with a comma.
Use a .04 gauge then tighten and re check it might just tighten up to .03 or try .05. So on and so forth until when you tighten and recheck it, it...
You just put feeler gauge between sensor and crank pickup to keep the distance. Bit like gapping a spark plug but not bending anything just...
This is an old thread I joined in 2014, but thanks for the welcome ;)
This is pic I have of sensor and there is alittle room to move it but not much[ATTACH]
Rolled the Olde Girl outside in lovely sun to take couple pics. Not much more going to be done now, got to get some funds together to get rear...
Used to have a Arai Giga many years ago in Kawasaki Green when I had a Kwaka zx7r. One of best helmets I have had and when you opened the air...
I used the Dual cone kit on mine from GSXR 1100. They just about fit with a bit of manipulation
Toying with idea of ditching air filter pods in favour of using half the airbox with panel filter. is this a good idea? What are peoples...
Got all the parts now to fit R1 wheel, brake caliper mount. Just waiting for funds to get myself a chop saw to cut the wheel spacers etc...
We shall see but if you see a Trophy going along with sparks flying off the swinger you know I may have made a mistake ;)
Lucky to have a landlord that has let me have a garage to use or else would be in same boat Learning a bit myself along the way. Don`t know if...
[ATTACH] Another view of rear wheel in situ. Sort bearings out next then chain alignment
Arse end fitted, now just got to get R1 wheel aligned. Fingers crossed my heath robinson way will work as to wheel alignment to frame. Might have...
Very good they were when I had my Suzi GS1000 Not so hot with Triumph though :). Q`s do you know best jetting for Trophy 1200 with pods? Ans =...
Clearing out rear of bike for rebuild. Exhaust mount chopped off . Repainting suspension knuckle and tie arms so look a bit better Will post more...
Hi Does anyone know if they standard 955 Daytona top yoke can be drilled to fit risers ? Is there an after market source for a top yoke conversion...
Yeeeeeha got it done. Just used washers around pivot on frame then used pivot bolt to pull out shaft as tightened it. Once pulled as far as could...
Have just had a proper read of Haynes and part I missed was about loosening the engine mount bolts. So lucky didn`t use big persuader. Thankyou...
Cheers will give it a look
Hi All after a bit of advice. Not taken a swing arm pivot bolt out of Trophy before The bolt itself doesn`t want to budge. Have only used a small...