Led Lights Wire Extension.

Can't speak by experience or electrical knowledge, but I would imagine all should be ok, if it was me I'd extend the wires temporarily and check out all is working as it should.

That's my thick planks worth advice,

 

Led is polarity sensitive i.e. positive must remain positive and negative must remain negative.
Crimp connectors will be the easiest but personally I would solder the wires end to end after twisting then insulate with heatshrink tubing (use a hot air gun or you could probably get away with a lighter if careful).

The current drawn by led equipment is typically very low so I wouldn't get too over concerned about the size of wire for a short extension.

Hope this helps?

 

Just an amplification on what @Eldon said. When joining wires end to end and soldering them, rather than twisting each end and then crossing them over and twisting before soldering, bring the two untwisted ends together and interlace the strands. With them interlaced by 10 to 15mm now twist the interlaced strands just a turn or two. This will give sufficient mechanical bond to hold them prior to soldering. The end result is nice slim join which is easy to slide the heat shrink over.

 

Also, if the new joint position will now be in a more exposed or arduous location, then I would double insulate. Easiest way is either to use another piece of the previous heatshrink over the top of the completed joint or the next size up depending on the diameters involved.

 

I had some of those on the Street Scrambler and also on the Berg until an incident with some deep ruts and a fence broke one so I replaced them with some twin beam versions. They throw a lot of light out for their size!

 

Yes. you are correct. The thicker the wire, the more current it will carry. I am running all LED on mine now. The current draw is minimal, and the lighting output is great. ...J.D.