Electrical/Engine managment

Hi just recently brought a 3 year old speed triple in standard form just out of storage, so apart from giving it a mini service decided to give it all the usual mods before use, including: exhausts and tail tidy etc. when fitting the indicators to the tail tidy i thought i heard a fuse blow so taking off the seat unit to investigate it set the alarm off and when disarming then re-arming it, the indicators weren't flashing as they were before so the alarm would not arm correctly and would keep going off, forgot to say data tool by the way, investigating further it was a 5 amp fuse that was blowing and after replacing, when rearming kept blowing the fuse then setting the alarm off once again, only when putting a 10 amp fuse in it seemed to sort it out, can anyone help with what the problem may be?

The following day after the above problem when starting up the bike i noticed the engine managment light was on, could this be due to the above fault or could this be due to straight through exhausts being fitted and just didn't notice the managment light being on when starting the bike after fitting the exhausts.

please anybodies help would be greatfully appreciated.

 

Hi, thanks,
exhausts are sp engineering and seem to run ok but will be getting remap soon, alarm fitted by dealer and i know idealy not a good idea to fit larger fuse but ran out of smaller and the only other option at the time was to leave the ignition turned on all night as the alarm would not set.

Indecators are normal bulb type so just a direct change.
Cheers

 

It was Bulldog Triumph at Wokingham/Winersh, and yes heard a lot of bad reports so wont be getting problem sorted there.

 

going to do Jack Lilly at sunbury , have heard they are well clued up

 

got some more 5 amp fuses today and fitted one and all seems ok now with alarm and indecators,
but still have engine management light on.
Has anyone out there had this from changing exhausts ?.

 

Hi only fitted end cans and touched nothing else on the system

 

Hi only fitted end cans

 

Not touched any sensors ,just fitted end cans.
Will be off to Jack lilleys tomorrow.
Thanks for the interest so far and anymore will be welcome

 

yeh thanks, Jack lilley says EM light will come on and register a fault if the battery ampage drops below a cirtain output which happened when i was having trouble with the fuse in the alarm, so yes now i need to go through the 3 heat cycles . THANKS FOR ALL THE HELP OUT THERE.

 

Thanks ill check it out.