Separate names with a comma.
Hi Alex, Back in 2013 with the Daytona's Showa rear shock I did use air, because I had a foot pump that would go to 200psi. It worked fine. As...
Hi Alex, Re the oil, lolachampcar recommends Mobil 1 ATF, the (LV) low viscosity version. I cannot get that in Australia, although there is an...
After a few tries, I ended up with this shim configuration. It provides firm but comfortable sportsbike suspension performance. Front NIX30 left...
I rode 1200km over a variety of roads. It's so much better! On bumpier roads I did get a couple of shocks I didn't like, so I'm motivated to do...
It worked! The rear suspension matches the front now. I can look down and see the front brake hoses flexing as the suspension moves (actually...
I was going to detail the changes since new in the left fork leg; 4 years ago: Reduced clamp shim from 15mm diameter to 10mm, to soften the whole...
I built this compression stack in the left fork leg. 8/26/0.10 8/24/0.15 8/10/0.15 new, crossover 8/22/0.10 8/20/0.15 8/18/0.15 8/16/0.15...
This is the compression stack in the left fork of my ST1050RS: 8/26/0.15 12/24/0.15 with 8/12/0.2 concentric 8/24/0.15 8/22/0.15 8/18/0.15...
I did this in my ST1050RS rear shock first because IMO the shock is more important to comfort than the forks. 6/20/0.10 was 0.15 6/18/0.15...
I verified in Ebay photos that the 1050RS shock build is TR9110, like mine, and the 1200RS fork build is FL9510, like lolachampcar’s. The...
I edited this update and the next one to eliminate extraneous info. My rear shock TR9110 compression stack originally looked like this. Shims ID...
I found what I need on Youtube [MEDIA] Nix 30 fork cartridge valve nut is a 13mm nut on an 8mm aluminium thread, thus the 8mm shim ID. No...
I bought this tool to remove/replace/torque the TTX36 shock's compression valve. I seem to have bought the last one. I was going to use a 5mm or...
There is no Oh AU, as far as I can tell. I have the Ohlins US phone number in NC. I'll try next week. It looks as if the FL9280 fork build (L and...
AUD300 worth of nitrogen bottle, regulator, hose, needle fill tool, bought on Ebay, on its way. Now for the shims. I just found the correct angle...