Who’s Got A Breaker T595? I Need...

If you know the measurements, google is your friend or a few calls to a manufacturer would mean you probably have a new one in a few days?
Just make sure that the thread pitch is correct (as i'm sure you would) and viola!

 

But you posted it was M5 x 10mm. I think at that screw size normal pitch is 1mm, fine thread is 0.75mm. Count the screw threads over a 5mm length of screw, should get you near enough to know which it is. Or get a stock metric nut and see if it screws onto the slightly tired looking original screw. Check someone like Accuscrews, they should sort you out. A spot of threadlock on it, and Bob's your chiropodist

Had a quick look. These, for example:
https://www.accu.co.uk/en/68-securi...arch_category=68&orderby=ranking&orderway=asc

 

Excellent ! Go for steel as it's going to be more than strong enough then I should think.

 

Not really. Stainless might be less likely to rust in and cause disassembly problems but not something you'll be taking apart every 10,000 miles I don't suppose. Thread length on a 5mm screw is 0.8mm. You can click somewhere on that page for more info, gives thread length, head diameter etc.

Yeah click on the pic of the screw and scroll down new page, full spec is at the bottom.

 

Either or either tbh as its not going to rust as it's inside the engine!
Just get the correct torque number and all sweet.
@Smilinjack beat me to it but totally correct of course.

 

I'd suggest that it doesn't need to be stainless and non-stainless usually has a higher tensile strength. What you clearly WILL need is a good threadlock on it!

 

I'm no engineer either (couldn't be much further from it!) but I'd think 243 should be fine - as long as the threads are clean and dry prior to application. Proper threadlock and correct torque are key, I reckon.

 

Sounds like job's a good un then.
Woop woop
Bearings, nuts and bolts,Oil seals will always be cheaper from stockists of those items than from Triumph, or any other motor manufacturer for that matter.
They are usually very helpful too and can help with sizing etc.

 

Absolutely. Accu are really good, and I use Simply Bearings quite often for, well, bearings, but oil seals too. Always a fraction of the price main dealers will try and hit you with, and you can get better quality too. I once ordered some head bearings from Ebay for my ZZR1200, shockingly poor. Pretty much same price from Simply got me a set of Timkens. Lesson learned

 

Awesome @StuarT595 I think we'll chalk that up as another win for the collective.