Featured Restoring A T100c

So in the last few weeks Su n me have completely stripped the bike and collected all the parts req for the rebuild. All the old parts have been cleaned and prepared and i should be painting the frame parts in the next week or so, this weekend we are detailing and prepping all the engine parts for assembly. Cleaned and polished the rods, new main bearing fitted and will go back together this week

 

So i managed to fit the rods to the crank with new big end shells and fit the crank into the new bearings and put the 2 crank case half's together, fitted 2 new lifter blocks and seals to the barrels and then have a trial fit of the barrels on the crank case Next job is fit new pistons and fix the barrels down.

 

Lifters back in the blocks and cam shafts fitted and timed, was going the fit pistons to rods and pop barrels on but i stupidly crushed the end of my finger lol nice big split so off for stitches :-(

 

Well i am back from AnE and have had it glued taped and its in a splint as its broken as well lol.

 

Lol, silly mistake by me but lesson learned, 4 weeks and all should be well.

 

Its good when you can laugh after

 

Don't worry, i have a plan. The engine is at a stage that it can go back in the frame so i am prepping the frame over the rest of the week and i will paint all the frame parts next week. Su has booked the following week off work and she will be rebuilding the cylinder head and doing other bits

 

So i have managed to get most of the major frame parts painted, not doing my finger any good as had first look at it the night before last and its still open a bit, i have redressed it and left plastic splint off and today it looks much better by allowing some air to get to it Pix of paintwork so far, this will allow us to start rebuilding it next week with Su being off work

 

It only takes a moment of stupidity and its done Lol, my finger is itching.

 

So easily done, good news they sorted your finger , i think i over did it this last week as i thought it would have healed by now so i am taking more care of it now.

 

Su n me had a bit of spare time today so we rebuilt the forks with there newly painted lower legs

 

Latest news, piston rings gapped and fitted, pistons on rods and barrels fitted cams are in and timed up. The rest of the engine will be done as soon as Su has finished the cyl head so we started assembling the frame parts.