Torque settings

Hi Pete, I'm a little confused - your question is in the SIII part of the forum but your signature says 'Tiger'. If your question does relate to the SIII, then '05 to '09 the engine mounting bracket-to-cylinder head bolts is 30Nm, all other mounting bolts are 80Nm. Hope this helps. :smile:

 

Bry you alright? Bit worried.. A sensible answer

 

OK, I'd been taking drugs at the time. x

 

Sorry, haven't got the manual for the new one yet. I wouldn't bank on the settings being the same - they've changed everything else - none of the bling from my '07 fits my new one!

 

pretty sure it tells you on the R&G instructions? or failing that the Speed handbook? If I hadn't had a couple of Abbot Ales and nearly a bottle of a rather cheeky Merlot I'd go up in the garage loft and dig my Speedy bits out to check...but as I have your'e on your own fella! :upyeah:
View attachment 2046

 

Hi

R and G instructions say 40nm for the crash bungs .

I've just bought a set myself but need to get 16mm socket and spanner.

I went for the ones that go under the rad covers. How the hell you get to tighten the nut on the inner side I ain't worked out. Hope the rad ain't got to come off, to gain access?

Cheers Jacko

 

Ring spanner and the nut taped into it - the rad stays where it is. You may need to remove the horn on the left side as it makes access easier.

 

Will have a go once I get 16mm socket from Halfrauds

Cheers all